Programming Instructions:
Note: This is the same for many Chrysler/Dodge/Jeep vehicles.
Grab your working remote. Push the LOCK button five times, allowing exactly two seconds to pass between each press of the LOCK button. Insert the ignition key and turn it to RUN. Push and hold UNLOCK on the working remote for 6 seconds. Push and hold PANIC for one second while continuing to hold UNLOCK. Release both buttons at the same time.
Push any button on the remote to program it. Then push any button on the remote that was already programmed. It has to be reprogrammed. The remote is now programmed to the vehicle. Turn the key to OFF.
JACOB says
Will this work for 2010 key they say that you need two keys in order to program your self otherwise you need a dealer
Thanks
Steve z says
Everywhere I have read I need 2 remotes. I just wanted to make sure this will work before I buy a new remote. If this does not work is there any other place I can go to get the remote programmed beside the dealer. They are charging a very large fee to program the remote
The Remote Guy says
Hey Steve, no, you definitely need two remotes to do this. I am not sure about this specific model, but I am pretty sure you need to have ONE WORKING remote for this to work. If you don’t have a working remote, then your only real option is to take it to a dealer or find a mechanic that will do this for you without charging an arm and a leg.
If anyone else, knows another option, please chime in!
Cheers!
Steve z says
Sorry meant to say 2 working remotes to program a new one. One last question. I currently have the 6 button remote. That one had one button that has no picture on it. If I buy a 7 button remote will it still work?
Connie says
My Town & Country manual states I can only program a new remote if have TWO existing remotes that work. If I only have one existing remote that works it says I have to have the dealer program the new one. Are you saying I can program a replacement remote with only ONE existing remote that works?