Programming Instructions:
Note: This is the same for many Chrysler/Dodge/Jeep vehicles.
Grab your working remote. Push the LOCK button five times, allowing exactly two seconds to pass between each press of the LOCK button. Insert the ignition key and turn it to RUN. Push and hold UNLOCK on the working remote for 6 seconds. Push and hold PANIC for one second while continuing to hold UNLOCK. Release both buttons at the same time.
Push any button on the remote to program it. Then push any button on the remote that was already programmed. It has to be reprogrammed. The remote is now programmed to the vehicle. Turn the key to OFF.
jim calvert says
It is impossible to push the panic button when the key is in the ignition
krea says
Its impossible to hold panic and unlock at the same time
Gary says
You cannot program Dodge remotes that have the key built in as part of the unit. The above method only works for separate remote fobs (that don’t have the key built in). Remotes with the key built in MUST be taken to a dealer or locksmith for programming.