Programming Instructions:
Note: Programming the remote requires the dealer if you have iDrive or the Smart Key.
Sit in the car’s driver’s seat. Verify that each of the vehicle’s doors, including the trunk, are closed. Insert the key straight into the ignition. Turn it to 1 and then back to OFF five times. Take the key out. Push and hold UNLOCK. While holding UNLOCK, press LOCK three times. Let go of the UNLOCK button. Congratulations, the key fob is programmed to the car.
Victor says
For completeness, I soluhd mention that not every cell in these data tables has an entry, i.e. not even a non-detect, and I just realized some tables are much sparser than others.Many readings, across all four monitoring categories, are missing entries for Cs-136, Te-129, and Te-129m, which probably reflects the available hardware. Data for these nuclides are absent for about 35% of the 229 air monitoring readings, about 18% of the 81 precipitations, and 2 of the 59 milks.But I was most surprised to realize that drinking water monitoring reported consistently only for I-131; in all but 3 locations, there are no data for any other nuclides. Those 3 readings (the two from Idaho and the one from Louisiana) report only Ba-140 and Co-60 results ( non-detect in every case).A final, minor, anomaly is that while only a few drinking water readings report Ba-140 and Co-60, only one milk location is missing Ba-140 and Co-60 (and all others are non-detect ).