Programming Instructions:
Sit in the driver’s seat. Open the driver’s door. Grasp the multifunction beam switch (high beam headlights). Pull it toward you and hold it in the position. Insert the key. Turn the key to “Acc.” Release the high beam switch, and then pull it rearward four times.
Push the “Lock” button on the remote to program it.
mike robinson says
I have a 1996 XK8, remote “cheeps” on the third pull of the high beam bar, then I press the “lock”button,but the remote still doesn’t work. Is it U/S?
Gaku says
I own the same 1996 XK8, you shall press ‘open’ button instead ‘close’ then red light on Jgate flashs once, if not press again. the rest of procedures you mentioned are correct. Good luck!!
Lee Spillman says
Thank you I hate going to the dealer