Programming Instructions:
Note: This is the same for many Chrysler/Dodge/Jeep vehicles.
Grab your working remote. Push the LOCK button five times, allowing exactly two seconds to pass between each press of the LOCK button. Insert the ignition key and turn it to RUN. Push and hold UNLOCK on the working remote for 6 seconds. Push and hold PANIC for one second while continuing to hold UNLOCK. Release both buttons at the same time.
Push any button on the remote to program it. Then push any button on the remote that was already programmed. It has to be reprogrammed. The remote is now programmed to the vehicle. Turn the key to OFF.
Bill says
Hi. I have just one working key fab for my 2009 Sebring 4-door sedan with 4 buttons; panic, lock, unlock, and trunk 2x.
I also have a spare door-only key which looks identical to the ignition key that’s in the original fob.
I got a spare fob from a used car lot that looks identical but has a slightly different number engraved on the back.
1.) Do you think it will work if I program it according to your PDF instructions?
2.) If I’m reading you correctly, when I program the used fob that I got from the used car lot, it might cause my one and only original to need reprogramming as well; so is there a risk of me blowing out the one and only original working fob and then having no working fobs?
3.) Worse yet, will my one and only ignition key possibly no longer start the car?
I look forward to hearing from you.
Thank you.
Bill