To program the key fob for the early model BMW 3 series including the 318 you have to
start with all doors, trunk and hood closed.
There are several different methods to try for the BMW 3Series so you may have to try more
than one. TIP – if one method fails the first time, try it a second time before moving on
to a new method as they can be tricky to get the steps right
METHOD ONE
Step one – Open the Trunk
Step two – get in the drivers side of the vehicle and close the door
Step three – insert the key into the ignition and turn it ‘ON’ and ‘OFF’ five times ending in the ‘OFF’ position.
Your car should indicate that it is ready for programming by emitting a loud ‘chirp’ noise.
Step four – open and close the drivers door (but stay in the seat)
Step five – press any button on the key fob.
The light should flash indicating that programming has been succesful
Step six – repeat steps three and four again for other remotes your wish to program.
Step seven – when you have finished programming key fobs, leave the door open, get out and close the trunk and then close the drivers door.
Your car should indicate that it has completed programming mode by emitting another loud ‘chirp’ noise.
METHOD TWO
Step one – get in the drivers side of the vehicle and close the door
Step two – insert the key into the ignition and turn it ‘ON’ and ‘OFF’ five times ending in the ‘OFF’ position.
Step three – remove the key from the ignition and hold down the UNLOCK button for 15 seconds while pressing the LOCK button three times rapidly.
Step four – release both buttons
Your car should indicate that the key fob has been programmed by cycling the door locks.
METHOD THREE
this method requires at least one working key fob. If it doesn’t work the first time switch the order of the keys.
Step one – get in the drivers side of the vehicle and close the door
Step two – insert the key into the ignition and turn it quickly from ‘ON’ to ‘OFF’. All the rest of the steps MUST occur in 30 seconds or less.
Step three – remove key #1 and hold it up near the roof on the drivers side by your shoulder (this is where the reciever is located)
Step four – hold down the UNLOCK button for 15 seconds while pressing the LOCK button three times rapidly.
Step five – release the unlock button
Your car should indicate that the key fob has been programmed by cycling the door locks.
Step six – repeat step three, four, five fast for key #2.
Stephen Trepagnier says
Do you have instructions to program a new key for my 2002 f150
LastXavier says
I see you don’t monetize your blog, don’t waste your traffic, you can earn additional bucks every month
because you’ve got hi quality content. If you want to know how to make extra bucks, search for: Mertiso’s tips best adsense alternative
MichelleSmall says
I have checked your page and i’ve found some duplicate content, that’s why you don’t rank high in google’s search results, but there is a tool that can help you to create 100% unique content, search for; Boorfe’s tips unlimited content
SophieChief says
I have checked your page and i have found some duplicate content, that’s why you
don’t rank high in google’s search results, but there is a tool that can help you to create 100%
unique articles, search for; boorfe’s tips unlimited content
Sean O’Reiley says
I have tried the first two methods several times but am still unable to program the new key flip fob to remotely open or close the vehicle. Unfortunately i ruined the only functioning diamond key opening it and looking for the transponder to insert into the new key (it must have been built into the board. Any suggestions?