Program Car Remotes

How to program a key fob for your car.

You are here: Home / Buick / Buick LeSabre / 1995 Buick Lesabre Remote Programming

1995 Buick Lesabre Remote Programming

2 Comments

Programming Instructions: [smartads]

Turn the Lesabre’s key to OFF. Leave it in the ignition. Open the driver’s door. Find the OBD data port on the left side of the dash, beneath the steering wheel. Insert a jumper pin into pins 8 and 4. The doors will lock and unlock. Close the driver’s door. Turn the ignition key to ON. Wait a few seconds, and then push and hold LOCK and UNLOCK on the key fob you are programming. Wait for the doors to unlock and lock. This takes about a minute. The remote is programmed.

Filed Under: Buick LeSabre

Comments

  1. Paul says

    November 7, 2014 at 2:49 pm

    Do you have instructions for a 94 Lesabre ?? Car does not have the standard OBDII computer diagnostic connector – there is no pin 4.

    Thx.

    Reply

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Copyright © 2025 · Haro Street Media Inc. · Log in