Learn to program the remote to your 2003 Buick Lesabre without any help from the dealer. This includes the Super model.
The Buick LeSabre was manufactured by the American automaker, General Motors, often known as GM. The LeSabre was sold between 1959 & 2005, being redesigned lots of times in the process. LeSabre’s are usually well equipped with features like power windows, power door locks, keyless entry. Some may have moonroofs or leathing upholsterey. Factory keyless remote ought to have been standard on most newer LeSabre models.
Programming Instructions: [smartads]
Turn the Lesabre’s key to OFF. Leave it in the ignition. Open the driver’s door. Find the OBD data port on the left side of the dash, beneath the steering wheel. Insert a jumper pin into pins 8 and 4. The doors will lock and unlock. Close the driver’s door. Turn the ignition key to ON. Wait a few seconds, and then push and hold LOCK and UNLOCK on the key fob you are programming. Wait for the doors to unlock and lock. This takes about a minute. The remote is programmed.
My LeSabre has no contact at pin 8.
Either row.
pin one, for one entire row, and four, five, and seven for the other row.
I see a lot of interesting posts on your website.
You have to spend a lot of time writing, i know how to
save you a lot of work, there is a tool that creates unique, SEO friendly articles in couple of minutes,
just type in google – laranita’s free content source
I read a lot of interesting articles here.
Probably you spend a lot of time writing, i know how to save you a
lot of work, there is an online tool that creates unique, google friendly
articles in minutes, just type in google – laranitas
free content source
My 2003 LeSabre has no contact pin on #8. Is there another way?
Mike. Were you able to find another way of programming your remote?
I am also lacking pin 8. Anyone have any more ideas?
This procedure only works on LeSabres up to 1999. Newer models have to be done by a tech with a scanner.
My 2003 has no 8 pin . What can I do now??
I tried to tap into 8 pin and it was closed or empty not allow the process to take place